District of Columbia DC DMV CDL General Knowledge Practice Test 1
Test 1 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real District of Columbia test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. How do objects appear in a convex mirror compared with a flat mirror?
Show answer
Answer B: Smaller and farther away than they really are, while a wider area is shown
A convex mirror shows a wider field but shrinks everything in it, so the driver must remember that vehicles are closer than they look.
-
2. You are told a posted bridge ahead has a weight limit lower than your gross weight. What must you do?
Show answer
Answer C: Take a route that avoids it, because a posted limit is a legal limit
A posted structure limit must be obeyed exactly as any other weight limit, so a heavier vehicle has to be routed around it.
-
3. What does gross vehicle weight mean, as opposed to gross vehicle weight rating?
Show answer
Answer B: The actual weight of the single vehicle plus everything it is carrying
Gross vehicle weight is what the vehicle actually weighs at that moment; the rating is the maximum the manufacturer allows it to weigh.
-
4. Why should a driver avoid shifting gears in the middle of a turn at an intersection?
Show answer
Answer D: Shifting during the turn takes a hand off the wheel and can cost you control
Pick the gear before you begin turning; shifting in the turn removes a hand from the wheel and can interrupt power just when you need steady control.
-
5. How does bracing differ from blocking when securing cargo?
Show answer
Answer B: Bracing runs from the upper part of the cargo to the floor or walls to keep it from moving, while blocking fits snugly against the cargo
Blocking is shaped to fit against the front, back or sides of a piece of cargo; bracing supports it from above so it cannot tip or shift.
-
6. You need to check your route on a navigation device. What is the correct approach?
Show answer
Answer D: Set it before the trip or after you have parked
Route programming is planning work, and it belongs to the time before the wheels turn or after the vehicle is safely parked off the roadway.
-
7. Why should you avoid using your lights to tell a following driver that it is safe to pass you?
Show answer
Answer B: You may misjudge the gap and the driver will act on your signal
The manual warns against signaling others to pass, because the responsibility for a head-on crash then rests on a judgment you could easily get wrong.
-
8. Where on the road are you most likely to find ice in cold weather?
Show answer
Answer B: On bridges, overpasses and shaded stretches, which freeze before the rest of the road
Bridges and overpasses lose heat from above and below, and shaded areas get no sun, so they ice over first and stay icy longest.
-
9. What fine does DC set for texting while driving a commercial motor vehicle?
Show answer
Answer A: 100 dollars
Texting while driving a commercial motor vehicle carries the same 100 dollar DC distracted driving fine as handheld phone use.
-
10. At 55 mph on dry pavement with good brakes, total stopping distance for a loaded heavy vehicle is roughly what?
Show answer
Answer B: About 400 feet or more
Perception, reaction, and braking together add up to roughly 400 feet or more, farther than the length of a football field.
-
11. What does the working load limit stamped on a chain or strap describe?
Show answer
Answer B: The maximum load the device is rated to hold in normal use
The working load limit is the rated safe capacity for everyday use, deliberately set well below the force that would break the device.
-
12. Why should high beams not be used in fog?
Show answer
Answer A: The light reflects back off the droplets and blinds you
Fog is made of water droplets that scatter light straight back at the driver, so a stronger beam makes the wall of glare worse rather than better.
-
13. The only way into a customer yard forces you to back toward the right, or blind, side of the vehicle. What should you do?
Show answer
Answer D: Use a helper and get out to check the path more often than you normally would
Blind side backing is allowed but far riskier, so it calls for a spotter you can see and for repeated checks of the path on foot.
-
14. You are pulling away from the curb after a delivery. Why is a mirror check needed first?
Show answer
Answer B: A cyclist or a vehicle may be coming up alongside you
Traffic and cyclists can arrive alongside a parked vehicle at any moment, so the mirrors must be checked immediately before pulling out.
-
15. An oncoming vehicle drifts across the center line into your lane. What is usually the safest move?
Show answer
Answer C: Steer to the right, toward the shoulder if necessary
Moving right keeps you away from the drifting vehicle and off the oncoming side; the other driver may swerve back and hit you if you go left.
-
16. What are you checking on the mud flaps during the walkaround?
Show answer
Answer C: That they are securely attached, not torn and not dragging on the ground
A flap that is torn or hanging loose stops shielding following traffic from spray and stones, and a dragging flap can catch and tear away on the road.
-
17. Which vehicle is most likely to be pushed around by a strong crosswind?
Show answer
Answer B: An empty van trailer
A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.
-
18. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
19. What is the payload of a truck?
Show answer
Answer C: The weight of the cargo the vehicle is carrying, that is the loaded weight less the empty weight
Payload is what is left of the legal or rated weight once the weight of the empty vehicle is taken off, and it is the weight of cargo that can be carried.
-
20. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
21. What are the rules for using your turn signal before a turn or lane change?
Show answer
Answer A: Signal early, keep the signal on until the turn is finished, then cancel it
An early, continuous signal tells others what you plan to do; cancelling afterward keeps the signal from misleading them.
-
22. During the engine compartment check, which leaks are you looking for?
Show answer
Answer D: Fuel, coolant, engine oil, power steering fluid and battery fluid
Every fluid in the compartment matters, because a fuel leak is a fire risk and a loss of coolant, oil, steering fluid or electrolyte can disable the vehicle.
-
23. How is the fluid level in an automatic transmission usually checked?
Show answer
Answer A: With the engine running, following the procedure in the operator manual
Most automatic transmissions are designed to be checked with the engine running, and the operator manual gives the exact conditions for that vehicle.
-
24. Part of looking well ahead is planning an out. What does that mean?
Show answer
Answer B: Keeping an escape path in mind in case traffic stops suddenly
Because a heavy vehicle often cannot stop in time, good drivers continuously note where they could steer if the space ahead closes.
-
25. How can a driver tell that a shipment includes hazardous materials?
Show answer
Answer B: The shipping paper describes them and the packages carry hazard warning labels
Hazardous materials are identified on the shipping paper with their shipping name and hazard class, and the packages themselves carry labels showing the hazard.
-
26. A doctor prescribes you a medicine that can cause drowsiness. What should you do?
Show answer
Answer A: Tell the doctor what you drive and not drive while affected
Both prescription and over the counter medicines can make a driver unsafe, so the medical professional must know the job and the driver must stay out of the seat while affected.
-
27. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
28. Your load projects more than 4 feet beyond the rear of the vehicle. How must the projecting end be marked?
Show answer
Answer A: With a red or orange flag by day and a red lamp after dark
Federal rules require a warning flag on a rear projecting load in daylight and a red lamp on the end of it when lights are required.
-
29. What are you looking for on the brake drums during the walkaround?
Show answer
Answer B: Cracks, dents and any oil or grease that has reached the friction surface
A cracked or badly scored drum can break apart under braking heat, and oil or grease on the friction surface destroys the braking effort at that wheel.
-
30. A load overhangs the rear of the trailer. What must the driver check before leaving?
Show answer
Answer D: That the overhang is marked as required, with flags or lamps as conditions demand
A projecting load has to be made visible to other drivers, with flags in daylight and lamps when lights are required, so nobody runs into what they cannot see.
-
31. What should you do before backing into a space you have not used before?
Show answer
Answer A: Get out and walk around to check the path, the clearance and any obstacles
Walking the area first reveals low obstructions, soft ground and objects that never appear in the mirrors.
-
32. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.
-
33. A dock crew loads all of the freight at the very back of a 48 foot van trailer. What are the two consequences?
Show answer
Answer A: The steering axle is relieved of weight and steering becomes light, and the trailer axles may go over the limit
Weight placed far to the rear lifts weight off the front of the combination, so the steering goes light while the trailer axles take too much of the load.
-
34. Which training must a first-time DC Class A or Class B applicant complete before the skills test?
Show answer
Answer D: Entry-Level Driver Training through an FMCSA-approved provider
Entry-Level Driver Training from an FMCSA-approved provider is required for first-time Class A and Class B applicants and for certain endorsements.
-
35. Your right wheels drop off the pavement onto a soft shoulder. What is the correct recovery?
Show answer
Answer A: Stay on the shoulder, ease off the accelerator, brake gently only once speed is down to about 20 mph, then steer back sharply and countersteer at once
Bringing speed down on the shoulder first avoids a violent sideways jolt, and countersteering the instant the tires are back on the pavement keeps the vehicle out of the next lane.
-
36. During the walkaround you find the reflective conspicuity tape along the trailer caked with road grime. What should you do?
Show answer
Answer B: Clean it, because dirty reflective material cannot make the trailer visible at night
Reflective sheeting only works if light can reach it and bounce back, so a dirty strip leaves the trailer effectively unmarked to approaching traffic.
-
37. Loading heavy freight on top of lighter freight has what effect on the vehicle?
Show answer
Answer B: It raises the center of gravity and makes a rollover more likely
A high center of gravity lets the vehicle tip more easily in curves or during a sudden swerve.
-
38. Which endorsements may DC DMV place on a commercial learner permit?
Show answer
Answer C: Only the school bus and passenger endorsements
DC DMV limits commercial learner permits to the S school bus and P passenger endorsements, each with its own restrictions.
-
39. You are loading lengths of large diameter pipe on a flatbed. What is needed besides the tiedowns?
Show answer
Answer D: Chocks, wedges or cradles that keep the pipe from rolling
Anything that can roll must be prevented from rolling by chocks, wedges, cradles or a similar device that is itself secured so it cannot come out.
-
40. A 60 foot combination traveling above 40 mph should hold how many seconds of following distance?
Show answer
Answer D: Seven seconds
Six seconds cover the 60 feet of vehicle length, and one extra second is added because the speed is above 40 mph.
-
41. At a rest area you find that the load has shifted although the straps still feel tight. What should you do?
Show answer
Answer C: Correct the load before driving on, since a shifted load is no longer secure
Movement means the securement has already failed once, and a load that has shifted can shift again, so it is put right before the vehicle moves.
-
42. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
43. Besides being uncomfortable, what can a series of hard, jerky brake applications do to a loaded combination?
Show answer
Answer A: Shift the load and push the trailer out of line behind the tractor
Sudden, uneven braking can move cargo forward and upset the alignment of a trailer, which is why stops should be made smoothly.
-
44. You are pulling a loaded pneumatic dry bulk trailer and approach an exit ramp posted at 35 mph. What is the safest approach?
Show answer
Answer C: Slow to well below the posted speed before the ramp begins
A dry bulk trailer carries its weight high and the load can move, so the ramp speed posted for a car is far too fast and the slowing must be finished before the curve.
-
45. The car in the next lane still has snow covering most of its windows. What should you assume?
Show answer
Answer C: That driver cannot see you and may move into your lane
A driver whose view is blocked cannot see the vehicles around, so you should assume you are invisible and stay out of that vehicle path.
-
46. Which items belong to the trailer part of the walkaround inspection?
Show answer
Answer D: Landing gear, doors, tires, wheels, lights, reflectors, frame and cargo securement
The trailer has its own running gear, lighting, structure and load, and all of it is the responsibility of the driver pulling it.
-
47. Taking your eyes off the road for about five seconds at highway speed means traveling roughly how far unseen?
Show answer
Answer A: About the length of a football field
At highway speed a five second glance away covers roughly 100 yards, which is far more road than any driver can afford to travel blind.
-
48. What is the most common cause of a front-wheel skid, where the vehicle keeps going straight even though you turn the wheel?
Show answer
Answer B: Driving too fast for the conditions
A front-wheel skid usually comes from too much speed for the traction available; the only cure is to let the vehicle slow down and stop turning or braking so hard.
-
49. Where is a dunnage bag used and how does it work?
Show answer
Answer D: Between pieces of cargo inside a van, where it is inflated to take up the gap
A dunnage bag is placed in the void between loads and inflated so the cargo is wedged and cannot move as the vehicle rolls and brakes.
-
50. You have stopped and a pedestrian is waiting to cross in front of your truck. Why should you not wave the person across?
Show answer
Answer C: Another driver may not stop, and your wave sends the person into danger
You cannot control what drivers in the other lanes will do, so you should not invite a pedestrian into a lane you do not command.